Motor-Sunroof - W/Control Unit - Installation
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
- If sunroof was open when drive motor was removed, carefully move glass panel into closed position and remove glass panel.
(Refer to BODY/SUNROOF/SUNROOF GLASS - REMOVAL
)
- Set lifter arm timing by manually sliding the mechanisms (1) in the track until timing holes in the trollies are aligned with the timing holes in the lifter arm cams (2) and insert pins (3) into the mechanisms to hold mechanisms in closed position.
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
- Place motor (3) into position and install screws (4) attaching motor to bracket (2).
- Tighten the screws (4) to 3 N.m (26 in. lbs.).
- If sunroof glass panel was removed previously, remove the timing pins and install the sunroof glass panel.
(Refer to BODY/SUNROOF/SUNROOF GLASS - INSTALLATION
)
- Partially install the headliner and connect the sunroof wiring electrical connectors.
(Refer to INTERIOR/HEADLINER - INSTALLATION
)
- Temporarily install sunroof switch and perform the sunroof motor teach procedure.
- Test sunroof operation, adjust glass as necessary.
(Refer to BODY/SUNROOF/SUNROOF GLASS PANEL ADJUSTMENT
)
- Complete the headliner installation.
(Refer to INTERIOR/HEADLINER - INSTALLATION
)