DTC P0057-O2 Sensor 2/2 Heater Circuit Low: Notes

Fig 1: O2 Sensor 2/2 Heater Circuit - Circuit Diagram

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

For a complete wiring diagram, refer to appropriate SYSTEM WIRING DIAGRAMS article.

• When Monitored: 

  Battery voltage above 10.6 volts, ASD is powered up, and O2 heater is on. 

• Set Condition: 

  Desired state does not match Actual state. 

  One Trip Fault. Three good trips to turn off the MIL. 

Always perform the PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding.