Diagnostic Test

TEST FOR TROUBLE CODES
1. Turn the ignition on.
2. With the scan tool, read DTC's
Q: Does the scan tool display any Body related DTC's?

No :
- Go To 2
Yes :
- Refer to the appropriate DTC and repair as necessary.
DOOR LOCK SWITCH SHORTED

Fig 1: Identifying Door Lock Switch Connector Terminals
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
1. Disconnect the Driver Window/Door Lock Switch connector.
Q: Is the voltage approximately 5.0?

Yes :
- Replace the Driver Window/Door Lock Switch.
- Perform BODY VERIFICATION TEST - VER 1. .
No :
- Go To 3
DRIVER DOOR LOCK SWITCH MUX CIRCUIT SHORT TO GROUND

Fig 2: Checking Driver Door Lock Switch MUX Circuit For Short To Ground
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
1. Turn the ignition off.
2. Disconnect the Cluster C2 connector.
3. Measure the resistance between ground and the (G161) Driver Door Lock Switch Mux circuit.
Q: Is the resistance below 10000.0 ohms?

Yes :
- Repair the (G161) Driver Door Lock Switch Mux circuit for a short to ground.
- Perform BODY VERIFICATION TEST - VER 1. .
No :
- Replace the Instrument Cluster.
- Perform BODY VERIFICATION TEST - VER 1. .