LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2008 >> Lancer ES, Standard >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Supplemental Restraint System (SRS) -- Lancer >> Air Bag Module(S) And Clock Spring >> Removal And Installation >> Side-Airbag Module >> Front Seatback Assembly With Side-Airbag Module Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Seatback Assembly With Side-Airbag Module Check

DANGER 

Never attempt to measure the circuit resistance of the air bag module (squib), even if you are using the specified tester. If the circuit resistance is measured with a tester, accidental air bag deployment will result, and possible serious personal injury  .

WARNING: If any improper part is found during the following inspection, replace the front seatback assembly with a new one. Dispose of the old one according to the specified procedure (Refer to AIR BAG MODULE AND SEAT BELT PRE-TENSIONER DISPOSAL PROCEDURES ).
  1. Check the air bag module deployment section for dents or deformation.
    2. Fig 1: Identifying Side-Airbag Module Deployment Section
    G05385073Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Check the connector for damage, the terminals for deformation, and the harness for binding.
scientia non olet · About LEMON Manuals