Fastener Tightening Specifications: Transaxle: Notes
FASTENER TIGHTENING SPECIFICATIONS
| Item | Specification |
|---|---|
| Reverse shift lever | 24 ± 4 N.m (17 ± 2 ft-lb) |
| Clutch housing-transaxle case mounting bolt | 50 ± 5 N.m (37 ± 3 ft-lb) |
| Reverse idler gear shaft mounting bolt | 78 ± 7 N.m (57 ± 4 ft-lb) |
| Poppet spring | 32 ± 2 N.m (24 ± 1 ft-ld) |
| Control housing mounting bolt | 24 ± 4 N.m (17 ± 2 ft-lb) |
| Select lever | 24 ± 4 N.m (17 ± 2 ft-lb) |
| Harness bracket | 24 ± 4 N.m (17 ± 2 ft-lb) |
| Back-up light switch | 32 ± 2 N.m (24 ± 1 ft-ld) |
| 1st-2nd speed rail switch | 32 ± 2 N.m (24 ± 1 ft-ld) |
| Hanger bracket | 24 ± 4 N.m (17 ± 2 ft-lb) |
| Stud adapter | 50 ± 5 N.m (37 ± 3 ft-lb) |
| Shift cable bracket | 24 ± 4 N.m (17 ± 2 ft-lb) |
| Transaxle-transfer mounting bolt | 69 ± 9 N.m (51 ± 6 ft-lb) |
| Stopper bracket mounting bolt | 19 ± 3 N.m (14 ± 2 ft-lb) |
| Select lever-select lever bracket connecting nut | 11 ± 2 N.m (97 ± 17 in-lb) |
| Clutch release bearing retainer mounting bolt | 10 ± 2 N.m (88 ± 17 in-lb) |
| Oil guide B | 10 ± 2 N.m (88 ± 17 in-lb) |
| Center differential drive gear mounting bolt | 133 ± 4 N.m (98 ± 2 ft-lb) |