Encrypted Code Registration Using Bar Code No

When the ignition key that starts the engine is replaced due to the replacement of the ignition key set, the ignition key cylinder, etc., the bar code No. must be used to register encrypted codes.

CAUTION:

Do not register the ignition keys other than the ignition key that starts the engine. (When replacing by the door lock key cylinder of illustration < A> or the glove box lid lock cylinder of illustration, the engine cannot start if the encrypted code is registered with the bar code on the ignition key supplied simultaneously. If the ignition key using for each lock cylinder and starting engine is used as a common ignition key, replace by the key set of illustration < C>).

Fig 1: Identifying Door Lock Key Cylinder
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
After the ignition key registration is finished, discard the bar code plate correctly at Mitsubishi dealer. The bar code plate has important information of the immobilizer system. Therefore, improper disposal of the bar code plate may decrease the security level.
When the transmitter is replaced, the transmitter must be registered after registering the encrypted code. For the registration of the transmitter, refer to HOW TO REGISTER SECRET CODE .

Fig 2: Identifying Glove Box Lid Lock Cylinder

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Required Special Tools:

MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: V.C.I.
- MB991827: M.U.T.-III USB Cable
- MB991910: M.U.T.-III Main Harness A

CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.

Connect scan tool MB991958 to the data link connector.
Turn the ignition switch to the "ON" position.

Fig 3: Identifying Key Set
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Choose "IMMOBILIZER" from the "POWER TRAIN" tab.

Fig 4: Scan Tool Display - Immobilizer
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Enter the VIN code of the vehicle that is registered. Then, press "OK" button.

Fig 5: Scan Tool Display - Diagnosis Vehicle Information
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 6: Scan Tool Display - VIN Code
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Select "Special Function."

Fig 7: Scan Tool Display - Special Function
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Select "Key Registration (Bar code No.)."

Fig 8: Scan Tool Display - Key Registration (Bar Code No)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Enter the password of the vehicle, and press the OK button.

Fig 9: Scan Tool Display - Password Enter Screen
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Enter the ID on the bar code plate which is attached to the ignition key, and press the OK button.

Fig 10: Scan Tool Display - ID Enter Screen
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 11: Scan Tool Display - ID
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
When the execution confirmation menu of the key registration (Bar code No.) is displayed, press the OK button.

Fig 12: Scan Tool Display - Key Registration (Bar Code No)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
When the key registration completion menu is displayed, press the OK button.

Fig 13: Scan Tool Display - Key Registration Completion Menu (Bar Code No)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.