Technical Description (Comment)
Current trouble
- Connector(s) or wiring harness in the CAN bus lines between the powertrain control module and the multi-center display unit (middle grade type), the power supply system to the powertrain control module, the powertrain control module itself, or the multi-center display unit (middle grade type) may be defective.
Past trouble
- Carry out diagnosis with particular emphasis on connector(s) or wiring harness in the CAN bus lines between the powertrain control module and the multi-center display unit (middle grade type), and the power supply system to the powertrain control module. For diagnosis procedures, refer to "How to cope with past trouble" (Refer to HOW TO USE TROUBLESHOOTING/INSPECTION SERVICE POINTS ).
NOTE:
For a past trouble, you may not find it by the M.U.T.-III CAN bus diagnostics even if there is any failure in CAN bus lines. In this case, refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION
.) and check the CAN bus lines. You can narrow down the possible cause of the trouble by referring to the DTC, which is set regarding the CAN communication-linked ECUs (Refer to CAN BUS LINE DIAGNOSTICS FLOW
).