>>A<< Dynamic Damper/Damper Band/ETJ Boot Installation
CAUTION:
There should be no grease adhered to the rubber part of the dynamic damper.
- Install the dynamic damper in the position (A) shown in the figure.
A: 221 ± 3 mm (8.70 ± 0.12 inches) <M/T-LH>
A: 426 ± 3 mm (16.77 ± 0.12 inches) <M/T-RH, CVT-RH>
- Secure the damper band.
- Wrap plastic tape around the shaft spline, and then install the ETJ boot band (small) and ETJ boot.