LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2009 >> Outlander ES, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Wireless Control Module (WCM)) >> Diagnosis >> Id Codes Registration Judgment Table >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Id Codes Registration Judgment Table: Notes

WARNING: This page is about a different car, the 2008 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Do not replace the engine control module (ECM) and WCM at the same time. When replacing several ECUs, always replace one ECU at a time, register the necessary IDs in it, and then replace the next ECU.

The transponder (a small transmitter) in the ignition key, WCM, and the ECM have their own ID codes stored in them. When the cases listed in the ID CODES REGISTRATION JUDGMENT CHART  occur, the ID codes must be registered in the WCM or ECM again.

NOTE: Up to eight ignition keys (key ID and keyless entry secret code) can be stored in the memory of WCM.
ID CODES REGISTRATION JUDGMENT CHART

Item Operation contents and procedure Reference page for registration contents
When the ECM is replaced
  1. Registration of ENG key code.
  2. VIN programmed.
 ENG key code & VIN reg (Refer to PRECAUTIONS BEFORE SERVICE ).
When WCM is replaced
  1. VIN programmed
  2. Register all the key IDs of the ignition keys again.
  3. Register all the keyless IDs of the ignition keys again.
  4. Register the TPMS transmitters
When the ignition key is added as a single unit
  1. Register all the key IDs of the ignition keys again.
  2. Register all the keyless IDs of the ignition keys again.
 Key Registration and Keyless ID Registration (Refer to ID CODES REGISTRATION PROCEDURE )
When the ignition key is lost as a single unit
  1. Register all the key IDs of ignition keys other than the lost one again.
  2. Register all the keyless IDs of ignition keys other than the lost one again.
When the ignition key is replaced by the full service key set or the handle lock service key set is replaced by the piece.
  1. Register the key ID of the replaced ignition key again. < Barcode No. input>
  2. Register the keyless ID for all the ignition keys again.
 Key Registration (Barcode No.) and Keyless ID Registration (Refer to ID CODES REGISTRATION PROCEDURE )
When the key(1) is replaced by the door service key set or glove box service key set is added by the piece. Operation is not needed -
When TPMS transmitter is replaced Register the TPMS transmitter Registering tire pressure sensor ID (Refer to ID CODES REGISTRATION PROCEDURE ).
NOTE:
(1) Key (the key that can be used to lock/unlock the door or glove box only)
scientia non olet · About LEMON Manuals