Key Interlock Mechanism Check/Adjustment
- Carry out the following check.KEY INTERLOCK MECHANISM CHECK/ADJUSTMENT
Inspection procedure Check conditions Items to be checked (Normal conditions) 1 Brake pedal: Depress Ignition switch position: LOCK (OFF) or removed The selector lever cannot be moved out of P position. 2 Ignition switch position: ON The selector lever can be moved from P position to other positions smoothly. 3 Transmission range: Other than P The ignition switch cannot be turned to the LOCK (OFF) position. 4 Transmission range: P The ignition switch can be turned to the LOCK (OFF) position smoothly. - If the normal conditions are not obtained after performing the above operations, install the key interlock cable in the following procedures (Automatic adjustment).
- Disconnect the key interlock cable connection (selector lever side). Refer to
CVT KEY INTERLOCK AND SHIFT LOCK MECHANISMS .CAUTION: Leave the ignition switch in the LOCK (OFF) position until the key interlock cable installation is completed.
- Move the selector lever to the P position and turn the ignition switch to the LOCK (OFF) position.
- Install the tip of the key interlock cable to the lock cam of the selector lever assembly, taking care not to twist the inner cable.
- Install the adjuster case with its lock guide pulled up (unlocked).
- Securely push down the lock guide to lock it.
- Disconnect the key interlock cable connection (selector lever side). Refer to
CVT KEY INTERLOCK AND SHIFT LOCK MECHANISMS .
NOTE:
The lock position of the key interlock cable is automatically adjusted by a spring.