Diagnostic Trouble Code Chart
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- During troubleshooting, a DTC code associated with other system may be set when the ignition switch is turned on with connector(s) disconnected. On completion, check all systems for DTC code(s). If DTC code(s) are set, erase them all.
- When the combination meter is required to be replaced as a result of the troubleshooting, the current driving distance and number of elapsed days to be used for service reminder function must be entered into the meter after the replacement. Therefore, read "Integrated mileage for reminder," "Integrated days for reminder," "Mileage until Extra reminder," "Months until Extra reminder," and "Current Schedule" from the meter before the replacement using the special function of scan tool MB991958, and note them. For the operation method of scan tool MB991958, refer to HOW TO SET BY OPERATING THE SCAN TOOL MB991958
. If "Integrated mileage for reminder" or "Integrated days for reminder" cannot be read by the scan tool MB991958, follow the method described below.
- For the driving distance for check warning, use the driving distance displayed on the multi information display.
- For the elapsed days for check warning, calculate the number of elapsed days from the delivery date to the customer (service remainder function start date) and current date.
DIAGNOSTIC TROUBLE CODE CHART
| DTC No. | Diagnostic item | Reference |
|---|---|---|
| B1200 | Malfunction of odometer | |
| B1201 | Abnormal fuel information | |
| B1208 | Malfunction of LCD heater | |
| B1209 | Test mode | |
| B2203 | VIN not programmed | |
| B2463 | The sticking of rheostat switch | |
| B2464 | The sticking of meter information switch | |
| B2465 | Ignition switch signal error | |
| U0019 | Bus off (CAN-B) | |
| U0100 | Engine control module CAN timeout | |
| U0141 | ETACS CAN timeout | |
| U0151 | SRS-ECU CAN timeout | |
| U0154 | Occupant classification-ECU CAN timeout | |
| U0164 | A/C-ECU or heater control unit CAN timeout | |
| U0168 | KOS-ECU or WCM CAN timeout | |
| U0184 | Audio CAN timeout | |
| U0197 | Hands free module CAN timeout | |
| U0245 | Audio visual navigation unit CAN timeout | |
| U1415 | Coding not completed/Data fail |