LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2010 >> Lancer Evolution GSR >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Wireless Control Module (WCM) - Lancer Evolution >> On-Vehicle Service >> Id Codes Registration Procedure >> Registration Using Scan Tool MB991958 (M.U.T.-III Sub Assembly) >> "Key Registration (Barcode No.)" METHOD
April 5, 2026: LEMON Manuals is launched! Read the announcement.

"Key Registration (Barcode No.)" METHOD

  1. When "Key Registration (Barcode No.)" screen is displayed, enter the password for the key registration and press the OK button.
    NOTE: If the wrong password is entered consecutively 5 times, the password entry for the key registration will be disabled for 16 minutes.
    Fig 1: Identifying Barcode Tag Point
    G06473074Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 2: Screen Display - OK Button
    G05384478Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Follow the message on the screen to enter the bar code No., and then press the OK button.
  3. When "Do you want to start?" is displayed, press the OK button to start the registration, or press the Cancel button to cancel the registration.
  4. "Completed" is displayed. Press the OK button to finish the registration.
    NOTE: When the key cannot be registered using scan tool MB991958, refer to INSPECTION PROCEDURE 2 "THE IGNITION KEY CANNOT BE REGISTERED USING SCAN TOOL"  .
    Fig 3: Screen Display - OK Button
    G05384479Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 4: Screen Display - Barcode
    G06483556Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals