Section 63 (Windshield Wiper System And Washer System - Lancer)
WARNING: This page is about a different variant/trim than selected.
- General Information
- Windshield Wiper And Washer Operation
- Special Tools
- Windshield Wiper And Washer Diagnosis
- Symptom Procedures
- General Description Concerning The Windshield Wiper And Washer
- General Circuit Diagram For The Windshield Wiper And Washer
- INSPECTION PROCEDURE 1: The windshield wipers do not work at all
- INSPECTION PROCEDURE 2: The windshield wipers do not work when the wiper switch is at the "INT", "Washer" or "Mist" position. However, the wipers work at low speed when the switch is at the "Lo" or "Hi" position
- INSPECTION PROCEDURE 3: Windshield wipers do not stop at the specified park position
- INSPECTION PROCEDURE 4: Windshield wipers do not work normally
- INSPECTION PROCEDURE 5: The windshield intermittent wiper interval cannot be adjusted by operating the windshield intermittent wiper interval control switch
- INSPECTION PROCEDURE 6: The windshield intermittent wiper interval is not changed according to the vehicle speed
- INSPECTION PROCEDURE 7: The rain sensitive AUTO wiper function does not work at all
- INSPECTION PROCEDURE 8: The rain sensitive AUTO wiper function works even though there is no rainfall
- INSPECTION PROCEDURE 9: Sometimes the rain sensitive AUTO wiper function works even though there is no rainfall
- INSPECTION PROCEDURE 10: The windshield washer does not work normally
- Inspection Procedure 11: The intelligent washing function does not work normally
- Inspection Procedure 12: Delayed finishing wipe function does not work normally
- Data List Reference Table
- On-Vehicle Service
- Windshield Wiper
- Windshield Washer
- Lighting Control Sensor