Electrical Circuit

WARNING: This page is about a different variant/trim than selected.

Check for the following operations.

Shift the selector lever to P position.

Using a jumper wire, connect the battery (+) to the selector lever assembly connector terminals No. 3 and No. 4, and the battery (-) to the terminal No. 6. Then, check the operation of shift lock solenoid.

SHIFT LOCK SOLENOID REFERENCE

Jumper wire	Shift lock solenoid
Connect	Operate
Disconnect	Not operate

Fig 1: Identifying Selector Lever Assembly Connector Terminals

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.