LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2010 >> Lancer Evolution SE >> Repair and Diagnosis (Single Page) >> External Pages >> Different variant/trim >> Section 111 (Windshield Wiper System And Washer System - Lancer Evolution) >> Windshield Wiper >> Inspection >> Windshield Wiper Motor At Stop Position Operation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Windshield Wiper Motor At Stop Position Operation

WARNING: This page is about a different variant/trim than selected.
  1. Connect the battery to the windshield wiper motor as shown in the illustration (A).
  2. Run the windshield wiper motor at low speed, then disconnect the battery in the middle of the motor rotation and check to see that the motor stops.
  3. Connect the battery to the windshield wiper motor as shown in the illustration (B).
  4. Connect the terminals of the windshield wiper motor connector as shown in the illustration (B).
  5. Check to see that the windshield wiper motor runs at low speed and then stops at the automatic stop position.
    Fig 1: Checking Windshield Wiper Motor Connector Terminal
    G05384544Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals