Delayed Finishing Wipe Function Inspection
WARNING: This page is about a different variant/trim than selected.
- When the washer lever of the column switch is operated for 0.5 second or longer with the ignition switch in the ACC or ON position, or when the intelligent washer function is enabled, the delayed finishing wipe function injects the washer fluid and operates the wiper. The wiper operates once for 6 seconds after the wiper operation is stopped. Check that the delayed finishing wipe function works normally.
- If not, carry out the troubleshooting. (Refer to INSPECTION PROCEDURE 11: THE INTELLIGENT WASHING FUNCTION DOES NOT WORK NORMALLY.
.)NOTE: Check that the delayed finishing wipe function is set by the customization function. (Refer to CUSTOMIZATION FUNCTION .)