Wiper/Washer Switch Continuity Check

WARNING: This page is about a different variant/trim than selected.

< VEHICLES WITHOUT LIGHTING CONTROL SENSOR>

CONTINUITY SPECIFICATION

Switch position		Tester connection	Specified condition
OFF		-	Open circuit
Windshield intermittent wiper interval adjusting knob		6 - 3	Operating the adjusting knob changes the resistance.
Windshield washer switch		6 - 7	Continuity exists (Less than 2 ohms)
Windshield wiper switch	Hi	6 - 8	Continuity exists (Less than 2 ohms)
	Lo	6 - 9	Continuity exists (Less than 2 ohms)
	Int	6 - 10	Continuity exists (Less than 2 ohms)
	Mist	6 - 11	Continuity exists (Less than 2 ohms)

Fig 1: Identifying Wiper/Washer Switch Connector Terminal - Without Lighting Control Sensor

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

< VEHICLES WITH LIGHTING CONTROL SENSOR>

Fig 2: Identifying Wiper/Washer Switch Connector Terminal - With Lighting Control Sensor

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

CONTINUITY SPECIFICATION

Switch position		Tester connection	Specified condition
OFF		-	Open circuit
Windshield rain sensitive wiper function adjusting knob		6 - 3	Operating the adjusting knob changes the resistance.
Windshield washer switch		6 - 7	Continuity exists (Less than 2 ohms)
Windshield wiper switch	Hi	6 - 8	Continuity exists (Less than 2 ohms)
	Lo	6 - 9	Continuity exists (Less than 2 ohms)
	Auto	6 - 10	Continuity exists (Less than 2 ohms)
	Mist	6 - 11	Continuity exists (Less than 2 ohms)