General Specifications
WARNING: This page is about a different variant/trim than selected.
GENERAL SPECIFICATION
| Item | Specification | ||||
|---|---|---|---|---|---|
| Rear axle | |||||
| Rear wheel bearing | Type | Unit bearing (double-row angular contact ball bearing) | |||
| Rear driveshaft | Type | Outer | EBJ | ||
| Inner | ETJ | ||||
| Shaft length(1) x Shaft diameter mm (in) | LH | 434 x 25 (17.1 x 0.98) | |||
| RH | 456 x 25 (18.0 x 0.98) | ||||
| Differential | |||||
| Reduction gear type | Hypoid gear | ||||
| Reduction ratio | 3.307 | ||||
| Number of teeth | Drive gear | 43 | |||
| Drive pinion | 13 | ||||
| Bearings (Outside diameter x Inside diameter) mm (in) | Side | 72 x 37 (2.8 x 1.5) <LH>, 92 x 67 (3.6 x 2.6) <RH> | |||
| Front | 62 x 25 (2.4 x 1.0) | ||||
| Rear | 72 x 35 (2.8 x 1.4) | ||||
|
|||||