LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2010 >> Lancer Evolution SE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 78 (Front Axle -- Lancer Evolution) >> Driveshaft Assembly >> Removal And Installation >> Installation Service Points >> >>B<< Washer/Front Driveshaft Nut Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

>>B<< Washer/Front Driveshaft Nut Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION: Do not apply the vehicle weight on the front wheel hub assembly before fully tightening the front driveshaft nut. Otherwise, the wheel bearing may be broken.
  1. Be sure to install the front driveshaft washer in the illustrated direction.
  2. Using special tool MB990767, tighten the driveshaft nut. At this time, tighten the nut to the specified lower limit torque so that the pin hole may align with cotter pin.

    Tightening torque: 144 - 176 N.m (107 - 129 ft-lb) 

  3. If the pin hole does not align with the pin, tighten the driveshaft nut [less than 176 N.m (129 ft-lb)] and find the nearest hole, then fit the cotter pin.
    Fig 1: Tightening Driveshaft Nut Using Special Tool MB990767
    G05394335Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals