LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2010 >> Lancer Evolution SE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 78 (Front Axle -- Lancer Evolution) >> On-Vehicle Service >> Hub Bolt Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Hub Bolt Replacement

WARNING: This page is about a different variant/trim than selected.

Required Special Tools: 

  1. Remove the front caliper assembly and front disk brake, and retain the front caliper assembly with a wire and the like to prevent from falling (Refer to FRONT AXLE HUB ASSEMBLY  ).
  2. Use special tool MB991618 to remove the hub bolts.
    Fig 1: Removing Hub Bolts Using Special Tool MB991618
    G05394324Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Install the plain washer to the new hub bolt, and install the bolt with a nut while holding the hub with special tool MB990767.
  4. Install the front brake disk and the front caliper assembly (Refer to FRONT AXLE HUB ASSEMBLY  ).
    Fig 2: Installing Bolt With Nut While Holding Hub With Special Tool MB990767
    G05432066Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals