Generator Assembly: Inspection: Brush

WARNING: This page is about a different variant/trim than selected.

Measure the length of the protrusion of the brush. Replace the brush if the protrusion length is shorter than the limit.
Limit: 2 mm (0.1 inch) minimum
Unsolder the lead of the brush. The brush will come out, becoming ready for removal.

Fig 1: Measuring Length Of Protrusion
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Install a new brush by pushing it into the holder as shown in the drawing and soldering the lead.

Fig 2: Identifying Solder Location
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.