Actuator Test Reference Table
ACTUATOR TEST REFERENCE
| ITEM NO. | INSPECTION ITEM | TEST CONTENT | INSPECTION REQUIREMENT | NORMAL CONDITION |
|---|---|---|---|---|
| 7 | 1st indicator light | Illuminate each indicator light for three seconds to the signal from the scan tool MB991958 (M.U.T.-III sub assembly). |
|
Shift indicator light illuminates. |
| 8 | 2nd indicator light | |||
| 9 | 3rd indicator light | |||
| 10 | 4th indicator light | |||
| 11 | 5th indicator light <5A/T> | |||
| 12 | A/T control relay | Actuator test in scope mode, data list No. 54. Control relay is OFF for three seconds. | Data list No. 54
|
|
| 1 | Low-reverse solenoid valve | Drive the solenoid valve specified by the scan tool MB991958 (M.U.T.-III sub assembly) at 50% duty for five seconds. No other solenoid valve should be energized. | The solenoid should click when activated | |
| 4 | Overdrive solenoid valve | |||
| 5 | Reduction solenoid valve <5A/T> | |||
| 3 | Second solenoid valve | |||
| 6 | Torque converter clutch solenoid valve | |||
| 2 | Underdrive solenoid valve |