<<C>> Engine Assembly Support

<Engine hanger MB991895 is used>
1. Set special tool MB991895 to the front fender mounting bolts (A and B) and the radiator support upper insulator mounting bolts (C and D), which are located in the engine compartment, as shown.
  
  Fig 1: Locating Strut Mounting Bolt
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. Set special tool MB991527 and MB991454 (chain) to hold the engine/transaxle assembly.
  
  Fig 2: Removing Engine Front Mounting Bracket
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
<Engine hanger MB991928 is used>
1. Assemble the engine hanger (special tool MB991928). Set following parts to the base hanger.
  - Slide bracket (HI)
  - Foot (standard) (MB991932)
  - Joint (140) (MB991931)
  Fig 3: Installing Special Tool On Hanger
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. Set the engine hanger (special tool MB991928) to the front fender mounting bolts (A and B) and the radiator support upper insulator mounting bolts (C and D), which are located in the engine compartment, as shown.
  NOTE: Adjust the engine hanger balance by sliding the slide bracket (HI).
  
  Fig 4: Locating Strut Mounting Bolt
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
3. Set special tools MB991527 and MB991454 (chain) to hold the engine/transaxle assembly.
Fig 5: Identifying Special Tool
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.