<<B>> Engine Assembly Support

Remove the engine hanger.

Fig 1: Removing Engine Hanger
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
After removing the intake manifold plenum stay (rear) and the engine hanger, set special tool MB992012 and MB992013 to each cylinder head.

Fig 2: Removing Intake Manifold Plenum Stay
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
<Engine hanger MB991895 is used>
1. Set special tool MB991895 to the front fender mounting bolts (A and B) and the radiator support upper insulator mounting bolts (C and D), which are located in the engine compartment, as shown.
  
  Fig 3: Locating Strut Mounting Bolt
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. Set special tool MB991454 to hold the engine/transaxle assembly.
Fig 4: Supporting Engine With Garage Jack
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
<Engine hanger MB991928 is used>

Assemble the engine hanger (special tool MB991928). Set following parts to the base hanger.
- Slide bracket (HI)
- Foot (standard) (MB991932)
- Joint (140) (MB991931)
Fig 5: Installing Special Tool On Hanger
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Set the engine hanger (special tool MB991928) to the front fender mounting bolts (A and B) and the radiator support upper insulator mounting bolts (C and D), which are located in the engine compartment, as shown.
NOTE: Adjust the engine hanger balance by sliding the slide bracket (HI).

Fig 6: Locating Strut Mounting Bolt
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Set special tools MB991454 to hold the engine/transaxle assembly.

Fig 7: Supporting Engine With Garage Jack
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.