Learning Procedures
LEARNING PROCEDURES
| Steps | Item | Contents | |
|---|---|---|---|
| 1 | Learning procedure for engine idling | Refer to ENGINE IDLING LEARNING PROCEDURE . | |
| 2 | Fluid cooling | Park the vehicle in a cooler place, stop the engine, and leave the vehicle until the fluid temperature is lowered to the ambient temperature. | |
| 3 | Learning in cold engine condition | (1) Fluid temperature measurement | Use M.U.T.-III to measure the fluid temperature. (Check that the fluid temperature is the same as the ambient temperature.) |
| (2) Line pressure and shift control learning | Let the engine idle for 20 seconds in the "D" range. | ||
| (3) Direct control learning | Run the vehicle at 40 - 50 km/h (25 - 31 mph) for 5 seconds in the "D" range with steady operation. | ||
| 4 | Learning in hot engine condition | (1) Fluid temperature adjustment |
CAUTION:
When the CVT fluid temperature does not increase to 80°C (176°F) in cold region, raise the fluid temperature to a maximum extent. Raise the fluid temperature to 80°C (176°F). |
| (2) Direct control learning | The same procedure as for "Learning in cold engine condition" | ||