LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2011 >> Lancer DE, Automatic CVT >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Continuously Variable Transaxle On-Vehicle Service - Except Lancer Evolution >> Transaxle Assembly >> Removal And Installation >> Installation Service Points >> >> D << Transaxle Control Cable (Transaxle Side) Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

>> D << Transaxle Control Cable (Transaxle Side) Installation

  1. Move the selector lever to the "N" range.
  2. Move the manual control lever to Neutral position.
  3. Align the hole at the end of the manual control lever and the hole in the inhibitor switch body flange (section A - A).
    NOTE: Insert a ø5 mm (0.2 inch) bar into the aligned holes in the transmission range switch body flange and on the tip of the manual control lever to position the transmission range switch body.
    Fig 1: Aligning Hole At End Of Manual Control Lever And Hole In Inhibitor Switch Body Flange (Section A - A)
    G07029350Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Use the adjusting nut to tighten the transmission control cable to the specified torque.

    Tightening torque: 9.5 ± 3.5 N.m (84 ± 31 in-lb) 

  5. Make sure that the transmission-side ranges that are corresponding to the transmission range operate and function without fail.
    Fig 2: Identifying Adjusting Nut And Transmission Control Cable
    G07029351Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals