LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2011 >> Lancer ES, 4D Hatchback, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Wireless Control Module (WCM) - Except Lancer Evolution >> Diagnosis >> Id Codes Registration Judgment Table >> Notes
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Id Codes Registration Judgment Table: Notes

CAUTION: Do not replace the engine control module (ECM) and WCM at the same time. When replacing several ECUs, always replace one ECU at a time, register the necessary IDs in it, and then replace the next ECU.

The transponder (a small transmitter) in the ignition key, WCM, and the ECM have their own ID codes stored in them. When the cases listed in the table below occur, the ID codes must be registered in the WCM or ECM again.

NOTE: Up to eight ignition keys (key ID and keyless entry secret code) can be stored in the memory of WCM.
ID CODES REGISTRATION JUDGMENT TABLE

Item Operation contents and procedure Reference for registration contents
When the ECM is replaced
  1. Register the ENG the key code.
  2. Write VIN.
ENG key code & VIN reg (Refer to HOW TO PERFORM VEHICLE IDENTIFICATION NUMBER (VIN) WRITING ).
When WCM is replaced
  1. Write VIN
  2. Register all the key IDs of the ignition keys again.
  3. Register all the keyless IDs of the ignition keys again.
  4. Register the TPMS transmitters
When the ignition key added individually(2)
  1. Register all the key IDs of the ignition keys again.
  2. Register all the keyless IDs of the ignition keys again.
Key Registration and Keyless ID Registration (Refer to ID CODES REGISTRATION PROCEDURE  )
When the ignition key is lost individually
  1. Register all the key IDs of ignition keys other than the lost one again.
  2. Register all the keyless IDs of ignition keys other than the lost one again.
When the ignition key is replaced by the full service key set or the steering lock service key set.
  1. Register the key ID of the replaced ignition key again. < Barcode No. input >
  2. Register the keyless ID for all the ignition keys again.
Key Registration (Barcode No.) and Keyless ID Registration (Refer to ID CODES REGISTRATION PROCEDURE  )
When the key(1) is replaced by the door service key set or trunk lid service key set. Operation is not needed -
When TPMS transmitter is replaced Register the TPMS transmitter Registering tire pressure sensor ID (Refer to ID CODES REGISTRATION PROCEDURE  ).
(1) Key (the key that can be used to lock/unlock the door or trunk lid only)
(2) When available, key registration should be done beginning with a key that has been registered.

SUPPLY UNIT LIST FOR INDIVIDUAL KEY 

SUPPLY UNIT LIST FOR INDIVIDUAL KEY

Ignition key (without transmitter)  Ignition key (with transmitter) < LANCER > 
G05384407Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
G05384408Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Ignition key (with transmitter) < LANCER SPORTBACK >  -
G05433235Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
-
KEY SUPPLY UNIT LIST FOR OTHER THAN INDIVIDUAL KEY (1 OF 2)

Full service key set < Vehicles with keyless entry system >  Full service key set < Vehicles without keyless entry system (LANCER) >  Steering lock service key set (A: Without transmitter, B: With transmitter) 
G06666139Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
G06666140Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
G07033021Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
KEY SUPPLY UNIT LIST FOR OTHER THAN INDIVIDUAL KEY (2 OF 2)

Door service key set (LH), Door service key set (RH) < Vehicles without keyless entry system > 
NOTE: Key (It can only be used for locking and unlocking, and it cannot start the engine.)
Trunk lid service key set < Vehicles without keyless entry system (LANCER) > 
NOTE: Key (t can only be used for locking and unlocking, and it cannot start the engine.)
G05384249Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
G05384416Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.