>>E<< 1ST-2ND Speed Synchronizer Hub Installation

1. Set the output shaft on the press support stand.
2. Check that the 1st-2nd speed synchronizer hub is in the correct installation direction, and put it on the output shaft.
3. Using special tools MD998812, MD998814 and MD998825, install the 1st-2nd speed synchronizer hub with the press.
4. Make sure that the outer synchronizer ring on the 1st speed gear side can rotate freely.

Fig 1: Identifying 1st-2nd Speed Synchronizer Hub

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Identifying Special Tools MD998812, MD998814 And MD998825

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.