Data List Reference Table
CAUTION:
- Driving tests always need two persons: one driver and one observer.
- When shifting the selector lever to "D" range apply the brakes should be applied so that the vehicle does not move forward <A/T>.
NOTE:
*: After the inspection is completed, disconnect the throttle position sensor connector, and then delete the diagnostic trouble code using scan tool MB991958. (Refer to
CRUISE CONTROL SYSTEM DIAGNOSIS ).
ITEM INSPECTION CHART
| M.U.T.-III SCAN TOOL DISPLAY | ITEM NO. | INSPECTION ITEM | INSPECTION REQUIREMENT | NORMAL CONDITION | |||
|---|---|---|---|---|---|---|---|
| APP sensor (main) | 11 | Accelerator pedal position sensor (main) | Ignition switch: "ON" | Accelerator pedal: Released | 735 - 1, 335 mV | ||
| Accelerator pedal: Gradually depressed | Increases in response to the pedal depression stroke | ||||||
| Accelerator pedal: Fully depressed | 4, 000 mV or more | ||||||
| Brake light switch | 74 | Stoplight switch | Brake pedal: Depressed | ON | |||
| Brake pedal: Released | OFF | ||||||
| Cancel code | 57 | Cancel code | Ignition switch: "ON" | The cancel code, which set when the auto-cruise control system was cancelled at the last time. | |||
| Cancel switch | 75 | Auto-cruise control switch | CANCEL | "CANCEL" switch: ON | ON | ||
| "CANCEL" switch: OFF | OFF | ||||||
| Clutch switch | 78 | Clutch pedal position switch <M/T> | Clutch pedal: Depressed | ON | |||
| Clutch pedal: Released | OFF | ||||||
| Cruise switch | 81 | Auto-cruise control system operation | Auto-cruise control system: active | ON | |||
| Auto-cruise control system: Inactive | OFF | ||||||
| Main switch | 86 | Auto-cruise control switch | CRUISE (MAIN) | "CRUISE" (MAIN) switch: "ON" | ON | ||
| "CRUISE" (MAIN) switch: "OFF" | OFF | ||||||
| Neutral switch | 88 | Transmission range switch <A/T> | Transmission range switch: "N" position | ON | |||
| Transmission range switch: Other than above | OFF | ||||||
| Normally closed brake switch | 89 | Stoplight switch (brake switch) | Brake pedal: Depressed | ON | |||
| Brake pedal: Released | OFF | ||||||
| Resume switch | 91 | Auto-cruise control switch | ACC/RES | "ACC/RES" switch: ON | ON | ||
| "ACC/RES" switch: OFF | OFF | ||||||
| Set switch | 92 | Auto-cruise control switch | COAST/SET | "COAST/SET" switch: ON | ON | ||
| "COAST/SET" switch: OFF | OFF | ||||||
| TP sensor (main) | 13 | Throttle position sensor (main)* |
|
Fully close the throttle valve with your finger | 300 - 700 mV | ||
| Fully open the throttle valve with your finger | 4, 000 mV or more | ||||||
| Engine: warming up, idling | No load | 500 - 630 mV <2.4L engine> 500 - 660 mV <3.8L engine> |
|||||
| A/C switch: "OFF" to "ON" | Voltage rises | ||||||
| Selector lever: "N" to "D" | Voltage rises | ||||||
| Vehicle speed sensor | 4 | Vehicle speed signal | Road test the vehicle | The speedometer and scan tool MB991958 display the same value. | |||