Section 9 (Manual Transaxle Overhaul)
WARNING: This page is about a different variant/trim than selected.
- General Description
- Special Tools
- Transaxle
- Disassembly And Assembly
- Notes
- Disassembly Service Points
- Adjustment Before Assembly
- Assembly Service Points
- >>A<< Output Shaft And Input Shaft Installation
- >>B<< 5TH Speed-Reverse Shift Fork/5TH Speed-Reverse Shift Rail/3RD-4TH Speed Shift Fork/3RD-4TH Speed Shift Rail Installation
- >>C<< Spring Pin Installation
- >>D<< Spacer And Outer Race Installation
- >>E<< Transaxle Case Installation
- >>F<< Sealing Cap Installation
- >>G<< Under Cover Installation
- >>H<< Control Housing Installation
- >>I<< Vehicle Speed Sensor Installation
- >>J<< Select Lever Installation
- Inspection
- Disassembly And Assembly
- Input Shaft
- Disassembly And Assembly
- Notes
- Disassembly Service Points
- Assembly Service Points
- >>A<< Oil Seal Installation
- >>B<< Ball Bearing Installation
- >>C<< Snap Ring Installation
- >>D<< Synchronizer Spring Installation
- >>E<< Synchronizer Ring Installation
- >>F<< 3RD-4TH Speed Synchronizer Hub Installation
- >>G<< Synchronizer Sleeve Installation
- >>H<< 4TH Speed Gear Sleeve Installation
- >>I<< 5TH Speed Gear Installation
- >>J<< Thrust Plate Installation
- >>K<< Thrust Plate Stopper Installation
- >>L<< Ball Bearing Installation
- >>M<< Snap Ring Installation
- Inspection
- Disassembly And Assembly
- Output Shaft
- Disassembly And Assembly
- Notes
- Disassembly Service Points
- Assembly Service Points
- >>A<< Roller Bearing Inner Race Installation
- >>B<< Snap Ring Installation
- >>C<< 1ST Speed Gear Sleeve Installation
- >>D<< Synchronizer Spring Installation
- >>E<< 1ST-2ND Speed Synchronizer Hub Installation
- >>F<< Synchronizer Sleeve Installation
- >>G<< 2ND Speed Gear Sleeve Installation
- >>H<< 3RD Speed Gear Installation
- >>I<< Snap Ring Installation
- >>J<< 4TH Speed Gear Installation
- >>K<< 5TH Speed Gear Sleeve Installation
- >>L<< Synchronizer Spring Installation
- >>M<< Synchronizer Ring Installation
- >>N<< 5TH Speed-Reverse Synchronizer Hub Installation
- >>O<< Synchronizer Sleeve Installation
- >>P<< Reverse Gear Sleeve Installation
- >>Q<< Ball Bearing Installation
- >>R<< Snap Ring Installation
- Inspection
- Disassembly And Assembly
- Reverse Idler Gear
- Vehicle Speed Sensor
- Select Lever
- Control Housing
- Clutch Housing
- Transaxle Case
- Differential
- Specifications