Encrypted Code Registration Using Barcode No.

When the ignition key that starts the engine is replaced due to the replacement of the ignition key set, the ignition key cylinder, etc., the barcode No. must be used to register encrypted codes.

Fig 1: Identifying Bar Code Tag

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

CAUTION:

Do not register the ignition keys other than the ignition key that starts the engine. (When replacing by the door service key set of illustration <A >, the engine cannot start if the encrypted code is registered with the barcode on the ignition key supplied simultaneously. If the ignition key using for each lock cylinder and starting engine is used as a common ignition key, replace by the full service key set of illustration.)
After the ignition key registration is finished, discard the barcode plate correctly at Mitsubishi dealer. The barcode plate has important information of the immobilizer system. Therefore, improper disposal of the barcode plate may decrease the security level.
When the transmitter is replaced, the transmitter must be registered after registering the encrypted code. For the registration of the transmitter, refer to HOW TO REGISTER SECRET CODE .

Fig 2: Identifying Door Service Key Set
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 3: Identifying Full Service Key Set
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Required Special Tools:

MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: V.C.I.
- MB991827: M.U.T.-III USB Cable
- MB991910: M.U.T.-III Main Harness A

CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.

Connect scan tool MB991958 to the data link connector.
Turn the ignition switch to the "ON" position.

Fig 4: Connecting Scan Tool To Data Link Connector
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Choose "IMMOBILIZER" from the "POWER TRAIN" tab.

Fig 5: Selecting "IMMOBILIZER" From "POWER TRAIN" Tab
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Enter the VIN code of the vehicle that is registered. Then, press "OK" button.

Fig 6: Display - Diagnosis Vehicle Information (1 Of 2)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 7: Display - Diagnosis Vehicle Information (2 Of 2)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Select "Special Function."

Fig 8: Selecting "Special Function
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Select "Key Registration (Barcode No.)."

Fig 9: Selecting "Key Registration (Barcode No)"
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Enter the password of the vehicle, and press the OK button.

Fig 10: Display - Password Entering Screen
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Enter the ID on the bar code plate which is attached to the ignition key, and press the OK button.

Fig 11: Display - ID Enter Screen On Bar Code Plate
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 12: Identifying Bar Code Plate
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
When the execution confirmation menu of the key registration (Barcode No.) is displayed, press the OK button.

Fig 13: Display - Key Registration (Barcode No.)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
When the key registration completion menu is displayed, press the OK button.

Fig 14: Display - Key Registration Completed Screen
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.