<<E>> Engine Assembly Supporting

< Engine hanger (special tool MB991895) is used>
1. Set special tool MB991895 (engine hanger) to the front fender assembling bolts (A and B) and (C and D) as shown in illustration.
  
  Fig 1: Setting Special Tool To Front Fender Assembling Bolts
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. Set special tool MB991527 and MB991454 (chain) to hold the engine/transaxle assembly.
  
  Fig 2: Holding Engine With Special Tool MB991527 & MB991454
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
< Engine hanger (special tool MB991928) is used>
1. Assemble the engine hanger (special tool MB991928). Set following parts to the base hanger.)
  - SLIDE BRACKET (HI)
  - FOOT (STANDARD) (MB991932) <FRONT SIDE>
  - JOINT (90) (MB991930)
  - FOOT (SHORT) (MB991933) <REAR SIDE>
    
    Fig 3: Assembling Engine Hanger (Special Tool MB991928)
    Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. Set special tool MB991928 (engine hanger) to the front fender assembling bolts (A and B) and (C and D) as shown in illustration.
  
  Fig 4: Setting Special Tool To Front Fender Assembling Bolts
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
3. Position special tool MB991527 and MB991454 (chain) to hold the engine/transaxle assembly.
  NOTE: Adjust the engine hanger balance by sliding the slide bracket (HI).
  
  Fig 5: Positioning Special Tool MB991527 & MB991454 On Engine/Transaxle Assembly
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.