LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2012 >> Galant ES >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Data List Reference Table
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Data List Reference Table

CAUTION:
  • When shifting the selector lever to "D" range, apply the brakes should be applied so that the vehicle does not move forward.
  • Driving tests always need two persons: one driver and one observer.
DATA LIST REFERENCE CHART

M.U.T.-III SCAN TOOL DISPLAY ITEM NO. INSPECTION ITEM INSPECTION REQUIREMENT NORMAL CONDITION
APP sensor (main) 11 Accelerator pedal position sensor (main) Ignition switch: "ON" Accelerator pedal: Released 735 - 1, 335 mV
Accelerator pedal: Gradually depressed Increases in response to the pedal depression stroke
Accelerator pedal: Fully depressed 4, 000 mV or more
Brake light switch 74 Stoplight switch Brake pedal: Depressed ON
Brake pedal: Released OFF
Cancel code 57 Cancel code Ignition switch: "ON" The cancel code, which set when the auto-cruise control system was cancelled at the last time.
Cancel switch 75 Auto-cruise control switch CANCEL "CANCEL" switch: ON ON
"CANCEL" switch: OFF OFF
Cruise switch 81 Auto-cruise control system operation Auto-cruise control system: active ON
Auto-cruise control system: Inactive OFF
Main switch 86 Auto-cruise control switch CRUISE (MAIN) "CRUISE" (MAIN) switch: "ON" ON
"CRUISE" (MAIN) switch: "OFF" OFF
Neutral switch 88 Transmission range switch Transmission range switch: "N" position ON
Transmission range switch: Other than above OFF
Normally closed brake switch 89 Stoplight switch (brake switch) Brake pedal: Depressed ON
Brake pedal: Released OFF
Resume switch 91 Auto-cruise control switch ACC/RES "ACC/RES" switch: ON ON
"ACC/RES" switch: OFF OFF
Set switch 92 Auto-cruise control switch COAST/SET "COAST/SET" switch: ON ON
"COAST/SET" switch: OFF OFF
TP sensor (main) 13 Throttle position sensor (main)(1)
  • Remove the intake air hose at the throttle body.
  • Disconnect the throttle position sensor connector, and then connect terminals 3, 4, 5 and 6 with the use of the special tool: MB991658 (Test harness).
  • Ignition switch: "ON"
 Fully close the throttle valve with your finger 300 - 700 mV
Fully open the throttle valve with your finger 4, 000 mV or more
Engine: warming up, idling No load 500 - 660 mV
A/C switch: "OFF" to "ON" Voltage rises
Selector lever: "N" to "D" Voltage rises
Vehicle speed sensor 4 Vehicle speed signal Road test the vehicle The speedometer and scan tool MB991958 display the same value.
(1) After the inspection is completed, disconnect the throttle position sensor connector, and then delete the diagnostic trouble code using use of scan tool MB991958. (Refer to HOW TO CONNECT THE SCAN TOOL (M.U.T.-III)  ).
scientia non olet · About LEMON Manuals