All Sensor Calibration (G And Yaw Rate Sensor, Steering Wheel Sensor, Brake Fluid Pressure Sensor)
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Before carrying out the calibration, check that the diagnostic trouble code related to the steering wheel sensor, G and yaw rate sensor, or brake fluid pressure sensor is not set.
CAUTION:
When the next operation has been completed, carry out the calibration to make ASC-ECU learn the neutral point of the steering wheel sensor, G and yaw rate sensor, and brake fluid pressure sensor.
- ASC-ECU replacement
CAUTION:
Carry out the calibration under the following conditions.
- The vehicle has one occupant (driver) only.
- Turn the steering wheel to set the wheels in the straight-ahead positions.
- The brake pedal is not depressed. (The stop light switch is OFF.)
- Park the vehicle on a level surface.CAUTION: Before connecting or disconnecting scan tool, always turn the ignition switch to the LOCK (OFF) position.
- Before setting scan tool, turn the ignition key to the LOCK (OFF) position.
- Turn the ignition switch to the ON position.
- Select "ABS/ASC/ASTC."
- Select "Special function."
- Select "Sensor calibration."
- Select "all sensor calibration."
- Before removing scan tool from the vehicle, turn the ignition key to the LOCK (OFF) position.