<< D >> Driveshaft And Hub Knuckle Assembly Disconnection

WARNING: This page is about a different variant/trim than selected.

CAUTION:

The magnetic encoder collects metallic particles easily, because it is magnetized. Make sure that the magnetic encoder does not collect metallic particles.
When removing the driveshaft, make sure that it does not contact with the magnetic encoder (integrated with the inner oil seal) to avoid damage.

Fig 1: Identifying Magnetic Encoder, Oil Seal And Wheel Bearing
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

If the driveshaft is seized, use special tools MB990242 and MB990244, MB991354 and MB990767 to push the driveshaft out from the hub.

Fig 2: Pushing Driveshaft From Hub Using Special Tools

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.