Transmission Oil Level Check

WARNING: This page is about a different variant/trim than selected.

Remove the engine room under cover front B assembly. (Refer to UNDER COVER .)
Remove the filler plug and gasket.
Check that the oil level is just below the lower edge of the filler plug hole.
Check that the oil is not excessively foul and has moderate viscosity.
Install the filler plug and new gasket, then tighten them to the specified torque.
Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb)
Install the engine room under cover front B assembly. (Refer to UNDER COVER .)

Fig 1: Identifying Oil Filler Plug & Oil Drain Plug
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Identifying Filler Plug Hole, Filler Plug & Gasket
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.