LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2012 >> Lancer SE >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Cruise Control System - Lancer >> On-Vehicle Service >> Cruise Control System Operation Check >> Speed-Increase Setting
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Speed-Increase Setting

  1. Start the engine.
  2. Press the "ON/OFF" switch (cruise control system: ON, "CRUISE" indicator light: illuminated.)
  3. Set to the desired speed, above approximately 40 km/h (25 mph.)
  4. Press the "ACC/RES" switch.
  5. Check to be sure that acceleration continues while the "ACC/RES" switch is pressed, and that the speed at the time it was released becomes the constant driving speed.
NOTE: Acceleration can be continued even if the vehicle speed has passed the high-speed limit [approximately 200 km/h (125 mph)]. But the constant driving speed when the "ACC/RES" switch is released will be recorded as the high-speed limit.
Fig 1: Locating Cruise Control ACC/RES Switch (2.0L Engine Non-Turbo, 2.4L Engine)
G08290788Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Fig 2: Locating Cruise Control ACC/RES Switch (2.0L Engine Turbo)
G08290789Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals