LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2013 >> Lancer ES, 4D Hatchback >> Repair and Diagnosis (Single Page) >> Transmission >> Transfer Case >> Continuously Variable Transaxle (CVT) Diagnosis & On-Vehicle Service - Lancer >> Transaxle Assembly >> Removal And Installation >> Installation Service Points >> >> D << Transaxle Control Cable (Transaxle Side) Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

>> D << Transaxle Control Cable (Transaxle Side) Installation

  1. Move the selector lever to the "N" range.
  2. Move the manual control lever to Neutral position.
  3. Align the hole at the end of the manual control lever and the hole in the inhibitor switch body flange (section A - A).
    NOTE: Insert a ø5 mm (0.2 inch) bar into the aligned holes in the transmission range switch body flange and on the tip of the manual control lever to position the transmission range switch body.
    Fig 1: Identifying Alignment Position Of Manual Control Lever And Transmission Range Switch Body Flange Hole
    G06481867Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Use the adjusting nut to tighten the transmission control cable to the specified torque.

    Tightening torque: 9.5 ± 3.5 N.m (84 ± 31 in-lb) 

  5. Make sure that the transmission-side ranges that are corresponding to the transmission range operate and function without fail.
    Fig 2: Identifying Transaxle Control Cable And Adjusting Nut
    G08293112Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals