Speedometer Check

WARNING: This page is about a different variant/trim than selected.

CAUTION:

Since the diagnostic trouble code may be stored in the ABS-ECU or ASC-ECU when checking the speedometer with speedometer tester, erase the diagnostic trouble code.
Do not accelerate or decelerate suddenly during servicing work.

Adjust the pressure of tires to the specified level (Refer to ON-VEHICLE SERVICE ).
Where applicable, ensure that the TPMS warning light is not illuminating or flashing.
Press the ASC OFF switch for 3 seconds or more to stop the ASC operation.
Set the vehicle onto a speedometer tester and place the rear wheels on a free roller.

Fig 1: Setting Vehicle Onto Speedometer Tester
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
To prevent the wheel from moving from side to side, attach tension bars to the tie-down hook, and secure both ends to anchor plates.

Fig 2: Tension Bars & Anchor Plates
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
To prevent the vehicle from moving, attach a chain or wire to the rear retraction hook, and make sure the end of the chain or wire is secured.

Check if the speedometer indicator range is within the standard values.

Standard value <Except vehicles for CANADA>:

SPEEDOMETER INDICATION CHART

Standard indication {mph (km/h)}	Indication tolerance {mph (km/h)}
10 (16)	8.5 - 11.5 (13.6 - 18.4)
25 (40)	23.5 - 26.5 (37.6 - 42.4)
50 (80)	48.5 - 51.5 (77.6 - 82.4)
75 (120)	73.5 - 76.5 (117.6 - 122.4)
100 (161)	98.5 - 102.5 (158.6 - 165.0)
125 (201)	123.5 - 127.5 (198.6 - 205.0)
150 (241)	148.5 - 153.5 (239.0 - 247.0)
175 (282)	173.5 - 179.0 (279.2 - 288.0)

Standard value <Vehicles for CANADA>:

SPEEDOMETER INDICATION CHART

standard indication {km/h (mph)}	Indication tolerance {km/h (mph)}
20 (12.4)	19 - 24 (11.8 - 14.9)
40 (24.8)	40 - 44 (24.8 - 27.3)
80 (49.7)	80 - 85 (49.7 - 52.8)
120 (74.6)	120.5 - 125.5 (74.9 - 78.0)
160 (99.4)	160.5 - 165.5 (99.7 - 102.8)
200 (124.3)	200.5 - 207.0 (124.6 - 128.6)
240 (149.1)	240.5 - 247.0 (149.4 - 153.5)
280 (174.0)	280.5 - 289.0 (174.3 - 179.6)

If not within the standard value, check the tire size. If an incorrect size of tire is used, replace it and check again. If the tire size is correct, a defect may be present in components and circuit between the ASC and the combination meter. Check the following items.
- ASC (refer to DIAGNOSIS ).
- Combination meter (refer to DIAGNOSTIC TROUBLE CODE CHART ).