Customization Function
WARNING: This page is about a different variant/trim than selected.
By operating the ETACS system or MMCS of scan tool MB991958, the following functions can be programmed. The programmed information is held even when the battery is disconnected.
ADJUSTMENT ITEM CHART
| Adjustment item (scan tool MB991958 display) | Adjustment item | Adjusting contents (scan tool MB991958 display) | Adjusting contents |
|---|---|---|---|
| ACC power auto cut | Time to ACC power cut-off when the ignition switch is in the ACC position | Disable | No function |
| 30 min | 30 minutes (initial condition) | ||
| 60 min | 60 minutes | ||
| Turn power source | Adjustment of turn-signal light operation condition | ACC or IG1 | Operable with ACC or ON position |
| IG1 | Operable with ON position (initial condition) | ||
| Comfort flasher | With/without comfort flasher function | Disable | No function |
| Enable | With function (initial condition) | ||
| Comfort flasher switch time | Switch operation time to activate the comfort flasher function | Normal | 0.4 second (initial condition) |
| Long | 0.8 second | ||
| Hazard answer back | Adjustment of the number of keyless hazard warning light answer back flashes | Lock:1, Unlock:2 | LOCK: Flashes once, UNLOCK: Flashes twice (initial condition) |
| Lock:1, Unlock:0 | LOCK: Flashes once, UNLOCK: No flash | ||
| Lock:0, Unlock:2 | LOCK: No flash, UNLOCK: Flash twice | ||
| Lock:2, Unlock:1 | LOCK: Flash twice, UNLOCK: Flash once | ||
| Lock:2, Unlock:0 | LOCK: Flash twice, UNLOCK: No flash | ||
| Lock:0, Unlock:1 | LOCK: No flash, UNLOCK: Flash once | ||
| Lock:0, Unlock:0 | No function | ||
| Sensitivity for auto light | Lighting control sensor sensitivity (illumination intensity) <vehicles with auto light> | Level 1 bright | High-high ambient brightness |
| Level 2 bright | High ambient brightness | ||
| Level 3 | Standard ambient brightness (initial condition) | ||
| Level 4 dark | Low ambient brightness | ||
| Level 5 dark | Low-low ambient brightness | ||
| Headlight auto cut customize | Adjustment of headlight automatic shutdown function | Disable | No function |
| Enable (C-spec.) | With function (initial condition) | ||
| Welcome light | Disabling or enabling welcome light function | Disabled | No function |
| Small light | Tail light illuminates. (initial condition) | ||
| Head light | Headlight illuminates. | ||
| Coming home light | Disabling or enabling coming home light function | Disabled | No function |
| 15 sec | Headlight illuminates for 15 seconds. | ||
| 30 sec | Headlight illuminates for 30 seconds. (initial condition) | ||
| 60 sec | Headlight illuminates for 60 seconds. | ||
| 180 sec | Headlight illuminates for 180 seconds. |