LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2013 >> Lancer ES, 4D Sedan, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Active Stability Control System (ASC) - Lancer Evolution) >> On-Vehicle Service >> G And Yaw Rate Sensor Calibration >> Vehicles With TC-SST (When The G And Yaw Rate Sensor Is Replaced)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Vehicles With TC-SST (When The G And Yaw Rate Sensor Is Replaced)

WARNING: This page is about a different variant/trim than selected.
  1. Perform Step  -15) of G and yaw rate sensor calibration vehicle without TC-SST.
  2. On the Menu, select "System selection."
  3. On the "System selection," select "ACD/AYC" in the "System table," and then click the "OK" button.
  4. In the "ACD/AYC" field, select "Special function".
  5. In the "Special function," select "Learn sensor neutral position."
  6. Among the selected items, select "Learn lateral G-sensor neutral position" and then press the "OK" button.
  7. "Learn lateral G-sensor neutral position: Are you sure to execute the selected item?
    NOTE: Check the execution conditions." is displayed. Then, press the "OK" button.
  8. "Execute command: Executed" is displayed. Then, press the "OK" button.
  9. Among the selected items, select "Learn G-sensor neutral position" and then press the "OK" button.
  10. "Learn G-sensor neutral position: Are you sure to execute the selected item?
    NOTE: Check the execution conditions." is displayed. Then, press the "OK" button.
  11. "Execute command: Executed" is displayed. Then, press the "OK" button.
  12. The neutral point is learned.
  13. Turn the ignition key to the LOCK (OFF) position, and remove scan tool from the vehicle.
scientia non olet · About LEMON Manuals