LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2013 >> Lancer ES, 4D Sedan, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Active Stability Control System (ASC) - Lancer Evolution) >> On-Vehicle Service >> Hydraulic Unit Check >> Hydraulic Unit Installation Adjustment
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Hydraulic Unit Installation Adjustment

WARNING: This page is about a different variant/trim than selected.

Refer to HYDRAULIC UNIT .

  1. Operate the pre-removal steps for the hydraulic unit.
  2. Remove all brake tubes.
  3. Remove the protector.
  4. Loosen the mounting bolt and nut of the hydraulic unit bracket.
  5. Install all brake tubes temporarily.
  6. Shake hydraulic unit to all directions with both hands to make the hydraulic unit bracket insulator fit with the unit.
  7. Install the hydraulic unit bracket with mounting bolt and nut not to load the brake tube.
  8. Install the protector.
  9. Install all brake tubes securely.
    NOTE: Install the flare nut taking care not to let the brake tube turn together.
  10. Operate the post-installation steps of the hydraulic unit.
scientia non olet · About LEMON Manuals