LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2013 >> Lancer ES, 4D Sedan, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 38 (Hands Free Module - Lancer Evolution) >> On-Vehicle Service >> Methods For Pairing And Pairing Deletion With BLUETOOTH® Device Using Steering Wheel Voice Control Switch >> Pairing A Device
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pairing A Device

WARNING: This page is about a different variant/trim than selected.
  1. Shift the shift lever to N (neutral) position and pull the parking brake lever.
  2. Turn the ignition switch to "ACC" or "ON" position.
  3. Press the "Speech" switch.
    Fig 1: Locating Speech Switch, Pick-Up Switch & Hang-Up Switch
    G07667378Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Say "Setup."
  5. Say "Pairing options."
  6. The voice guide will say "Select one of the following: pair, edit, delete, or list?"
  7. Say "Pair."
  8. The voice guide will say "Please say a 4-digit pairing code."
  9. Say a 4 digit number. The 4 digit number will be registered as a pairing code for the device.
    • When the confirmation function is on, the system will confirm whether the number said is acceptable. Answer "Yes" to go Step 10. Say "No" to return to pairing code selection.
      NOTE:
      • The pairing code entered here is only used for the Bluetooth® connection certification. It is any 4-digit number the user would like to select.
      • Remember the pairing code as it needs to be keyed into the device later in the pairing process.
      • Depending on the connection settings of the bluetooth® device, this code may have to be entered each time you connect the bluetooth® device to the hands free module. For the default connection settings, refer to the instructions for the device.
  10. The voice guide will say "Start pairing procedure on device. See pairing device owner's manual for instructions." Refer to the owner's manual for your device and enter into the device the pairing code that was registered in Step  9.
  11. When this system finds a Bluetooth® device, the voice guide will say "Please say the name of the device after the beep."
  12. After you hear the beep, name the device by saying a name of your preference.
    NOTE: When the confirmation function is on, after repeating the device tag you have said, the voice guide will ask "Is this correct?" Answer "Yes".

    To change the device tag, answer "No" and then say the device tag again.

  13. The voice guide will say "Pairing complete," after which a beep will be played and the pairing process will end.
scientia non olet · About LEMON Manuals