LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2013 >> Lancer Evolution GSR >> Repair and Diagnosis (Single Page) >> Transmission >> Manual Trans >> Manual Transaxle On-Vehicle Service - Lancer Evolution >> Diagnosis <S-AWC (Super All Wheel Control)> >> Diagnostic Trouble Code Procedures >> DTC C1617: AWC CAN Main Data System (Data Not Received) >> Diagnostic Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Procedure

  1. STEP 1. Scan tool CAN bus diagnostics 

    Using scan tool MB991958, diagnose the CAN bus lines.

    Q: Is the check result normal? 

    1. YES:  Go to Step  3.
    2. NO:  Repair the CAN bus lines. (Refer to TROUBLESHOOTING .) After repairing the CAN bus line, go to Step 2.
  2. STEP 2. Check whether the DTC is reset. 

    Q: Is DTC No. C1617 set? 

    1. YES:  Go to Step 3.
    2. NO:  This diagnosis is complete.
  3. STEP 3. Scan tool diagnostic trouble code 

    Check if the AWC-related DTC No. U0100, U0101, U0121, U0126, or U0141 is set. (Refer to DIAGNOSTIC TROUBLE CODE CHART  .)

    Q: Is the DTC set? 

    1. YES:  Perform the relevant troubleshooting.
    2. NO:  Go to Step 4.
  4. STEP 4. Scan tool diagnostic trouble code 

    Q: Is the DTC set? 

    1. YES:  Perform the relevant troubleshooting.
    2. NO:  Go to Step 5.
  5. STEP 5. Check whether the DTC is reset. 

    Q: Is DTC No. C1617 set? 

    1. YES:  Replace the AWC-ECU. (Refer to AWC-ECU  .) Then go to Step 6.
    2. NO:  Intermittent malfunction. (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION .)
  6. STEP 6. Check whether the DTC is reset. 

    Q: Is DTC No. C1613 set? 

    1. YES:  Return to Step  1.
    2. NO:  This diagnosis is complete.
scientia non olet · About LEMON Manuals