LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2013 >> Lancer Evolution GSR >> Repair and Diagnosis (Single Page) >> Transmission >> Manual Trans >> Manual Transaxle Overhaul - Lancer Evolution >> Transaxle >> Disassembly And Assembly >> Assembly Service Points >> >>G<< Transaxle Case Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

>>G<< Transaxle Case Installation

  1. Completely degrease the FIPG-applied surface so that water and oil including the old sealant cannot adhere to the surface coated with the sealant.

    Never touch the degreased surface by hand.

  2. Apply a bead (approximately 2.5 mm (0.10 inch) thick) of specified sealant to the transaxle case as shown in illustration below.

    Specified sealant: Mitsubishi Motors Genuine Part No. MD997740 or equivalent 

    Fig 1: Sealant Applying Area On Transaxle Case
    G05393962Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals