DIAGNOSTIC ITEM 20: Diagnose When The Scan Tool Cannot Receive The Data Sent By Radio And CD Player Or CD Changer: Diagnosis
Required Special Tools:
- MB991223: Harness Set
- MB992006: Extra Fine Probe
- STEP 1. Check joint connector (CAN1) C-105 and radio and CD player or CD changer connector C-107 for loose, corroded or damaged terminals, or terminals pushed back in the connector. CAUTION:
The strand end of the twisted wire should be within 10 cm (4 inches) from the connector. For details refer to SERVICE PRECAUTIONS .
Q: Are joint connector (CAN1) C-105 and radio and CD player or CD changer connector C-107 in good condition?
- YES: Go to Step 2.
- NO: Repair the damaged parts.
- STEP 2. Check the wiring harness between joint connector (CAN1) C-105 and radio and CD player or CD changer connector C-107 for open circuit. CAUTION:
Strictly observe the specified wiring harness repair procedure. For details refer to SERVICE PRECAUTIONS .
- Disconnect joint connector (CAN1) C-105 and radio and CD player or CD changer connector C-107, and check the wiring harness.
- Check the wiring harness between joint connector (CAN1) C-105 (terminal 8) and radio and CD player or CD changer connector C-107 (terminal 23)
OK: Continuity exists (2 Ω or less)
- Check the wiring harness between joint connector (CAN1) C-105 (terminal 19) and radio and CD player or CD changer connector C-107 (terminal 33)
OK: Continuity exists (2 Ω or less)
Q: Is the wiring harness between joint connector (CAN1) C-105 and radio and CD player or CD changer connector C-107 in good condition?
- YES: Check the power supply circuit of the radio and CD player or CD changer. Refer to TROUBLE SYMPTOM CHART .
- NO: Repair the wiring harness between joint connector (CAN1) C-105 and radio and CD player or CD changer connector C-107.