DTC U0155: Meter CAN Timeout: Diagnosis

WARNING: This page is about a different variant/trim than selected.

Required Special Tools:

MB991958 Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: V.C.I.
- MB991827 M.U.T.-III USB Cable
- MB991910 M.U.T.-III Main Harness A

STEP 1. Using scan tool MB991958, diagnose the CAN bus line
CAUTION:
To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
1. Connect scan tool MB991958. Refer to "HOW TO CONNECT THE SCAN TOOL (M.U.T.-III) ."
2. Turn the ignition switch to the "ON" position.
3. Diagnose the CAN bus line.
4. Turn the ignition switch to the "LOCK" (OFF) position.
Q: Is the CAN bus line found to be normal?
- YES: Go to Step 2.
- NO: Repair the CAN bus line. (Refer to CAN BUS DIAGNOSTICS TABLE ).
  
  Fig 1: Connecting Scan Tool To Data Link Connector
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
STEP 2. Using scan tool MB991958 read the combination meter diagnostic trouble code.
Check whether a combination meter DTCs are set or not.
1. Turn the ignition switch to the "ON" position.
2. Check for combination meter DTCs.
3. Turn the ignition switch to the "LOCK" (OFF) position.
Q: Is the DTC set?
- YES: Diagnose the combination meter (Refer to TROUBLESHOOTING ).
- NO: Go to Step 3.
STEP 3. Using scan tool MB991958, read the ETACS-ECU diagnostic trouble code.
Check if the DTC U0155 is set to the ETACS-ECU.

Q: Is the DTC set?
- YES: Go to Step 4.
- NO: Go to Step 5.
STEP 4. Recheck for diagnostic trouble code.
Check again if the DTC is set to the CAN box unit.
1. Erase the DTC.
2. Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
3. Check if DTC is set.
4. Turn the ignition switch to the "LOCK" (OFF) position.
Q: Is the DTC set?
- YES: Replace the combination meter.
- NO: The trouble can be an intermittent malfunction such as a poor connection or open circuit in the CAN bus lines between the combination meter and the CAN box unit (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTIONS ).
STEP 5. Recheck for diagnostic trouble code.
Check again if the DTC is set to the CAN box unit.
1. Erase the DTC.
2. Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
3. Check if DTC is set.
4. Turn the ignition switch to the "LOCK" (OFF) position.
Q: Is the DTC set?
- YES: Replace the CAN box unit.
- NO: The trouble can be an intermittent malfunction such as a poor connection or open circuit in the CAN bus lines between the combination meter and the CAN box unit (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTIONS ).