LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2013 >> Lancer Evolution MR >> Repair and Diagnosis (Single Page) >> Restraints >> Passive Restraints >> Supplemental Restraint System (SRS) - Lancer Evolution >> Driver's Air Bag Module And Clock Spring >> Removal And Installation >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal And Installation: Notes

WARNING:
  • Never attempt to disassemble or repair the air bag modules or clock spring. If faulty, replace it.
  • Do not drop the air bag modules or clock spring or allow contact with water, grease or oil. Replace it if a dent, crack, deformation or rust is detected.
  • The air bag modules should be stored on a flat surface with the pad cover facing upward. Do not place anything on top of it.
  • Do not expose the air bag modules to temperatures over 93°C (200°F).
  • After the air bag deployment, replace the air bag module with a new one. Also, check the clock spring, and replace with a new part if there is an abnormality.
  • Wear gloves and safety glasses when handling air bags that have already deployed.
  • An undeployed air bag module should only be disposed of in accordance with the procedures (Refer to AIR BAG MODULE AND SEAT BELT PRE-TENSIONER DISPOSAL PROCEDURES  ).
  • When removing and installing the front passenger seat, be sure to carry out accuracy check of the occupant classification sensor after the seat has been installed in the vehicle (Refer to ON-VEHICLE SERVICE  ).
scientia non olet · About LEMON Manuals