Fuel Level Sensor (Sub) Replacement

Remove the rear seat cushion assembly. (Refer to REAR SEAT ASSEMBLY ).
Remove the floor inspection lid (RH).

Fig 1: Floor Inspection Lid (RH)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Disconnect the fuel level sensor (sub) connector.

Fig 2: Fuel Level Sensor (Sub) Connector
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

CAUTION:
Pay attention not to damage the fuel level sensor (sub) and the float of the fuel level sensor (sub) when withdrawing it from the service hole.
Remove the fuel level sensor (sub) mounting nuts, and remove the fuel level sensor (sub) from service hole.

Fig 3: Locating Fuel Level Sensor (Sub) Mounting Nuts
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Replace the fuel level sensor (sub) gasket with a new one.
CAUTION:
Pay attention not to damage the fuel level sensor (sub) and the float of the fuel level sensor (sub) when installing it to the fuel tank through the service hole.
Install the fuel level sensor (sub) to the fuel tank through the service hole, and tighten the mounting nuts to the specified torque.
Tightening torque: 2.5 ± 0.4 N.m (22 ± 4 in-lb)
Connect the fuel level sensor (sub) connector.

Fig 4: Fuel Level Sensor (Sub) Connector
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Install the floor inspection lid (RH).
Install the rear seat cushion assembly. (Refer to REAR SEAT ASSEMBLY ).