DTC U0195: Satellite Radio CAN Timeout: Diagnosis

Required Special Tools: 

• MB991958 Scan Tool (M.U.T.-III Sub Assembly)
  • MB991824: V.C.I.
  • MB991827 M.U.T.-III USB Cable
  • MB991910 M.U.T.-III Main Harness A

1. STEP 1. Using scan tool MB991958, diagnose the CAN bus line 
   CAUTION:

   To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.

   1. Connect scan tool MB991958. Refer to "HOW TO CONNECT THE SCAN TOOL (M.U.T.-III)  ."
   2. Turn the ignition switch to the "ON" position.
   3. Diagnose the CAN bus line.
   4. Turn the ignition switch to the "LOCK" (OFF) position.

   Q: Is the CAN bus line found to be normal? 

   • YES:  Go to Step 2.
   • NO:  Repair the CAN bus line. (Refer to DIAGNOSIS ).
     Fig 1: Connecting Scan Tool To Data Link Connector

     Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. STEP 2. Using scan tool MB991958 read the satellite radio tuner diagnostic trouble code. 

   Check whether a satellite radio tuner DTCs are set or not.

   1. Turn the ignition switch to the "ON" position.
   2. Check for satellite radio tuner DTCs.
   3. Turn the ignition switch to the "LOCK" (OFF) position.

   Q: Is the DTC set? 

   • YES:  Diagnose the satellite radio tuner. (Refer to SATELLITE RADIO TUNER - LANCER EVOLUTION .)
   • NO:  Go to Step 3.
3. STEP 3. Using scan tool MB991958, read the SRS-ECU diagnostic trouble code. 

   Check if the DTC U0195 is set to the SRS-ECU.

   Q: Is the DTC set? 

   • YES:  Go to Step 4.
   • NO:  Go to  Step 5.
4. STEP 4. Recheck for diagnostic trouble code. 

   Check again if the DTC is set to the CAN box unit.

   1. Erase the DTC.
   2. Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
   3. Check if DTC is set.
   4. Turn the ignition switch to the "LOCK" (OFF) position.

   Q: Is the DTC set? 

   • YES:  Replace the satellite radio tuner.
   • NO:  The trouble can be an intermittent malfunction such as a poor connection or open circuit in the CAN bus lines between the satellite radio tuner and the CAN box unit (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTIONS ).
5. STEP 5. Recheck for diagnostic trouble code. 

   Check again if the DTC is set to the CAN box unit.

   1. Erase the DTC.
   2. Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
   3. Check if DTC is set.
   4. Turn the ignition switch to the "LOCK" (OFF) position.

   Q: Is the DTC set? 

   • YES:  Replace the CAN box unit.
   • NO:  The trouble can be an intermittent malfunction such as a poor connection or open circuit in the CAN bus lines between the satellite radio tuner and the CAN box unit (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTIONS ).